Winding Acclaim Garage Doors Scottsdale AZ springs is an essential task for maintaining the proper functioning of your garage door. While it can be a challenging process, with the right knowledge and precautions, you can successfully wind your garage door springs.
This step-by-step guide will provide you with detailed instructions on how to wind your garage door springs safely and effectively.
Note: Before attempting to wind garage door springs, it is crucial to prioritize your safety. If you are unsure about any step, it is recommended to consult a professional garage door technician.
Step 1: Gather the Necessary Tools and Safety Equipment Before starting, make sure you have the following tools and safety equipment readily available:
- Safety glasses
- Leather gloves
- Winding bars (appropriate size for your springs)
- A ladder
- C-clamps or locking pliers
- Socket wrench set
Step 2: Identify the Type of Garage Door Springs Garage door springs come in two main types: torsion springs and extension springs. It’s important to determine which type your garage door has, as the winding process differs for each.
Step 3: Unplug the Garage Door Opener For safety reasons, disconnect the power supply to your garage door opener to prevent accidental opening or closing during the winding process.
Step 4: Release Tension from the Springs To release tension from the springs, open the garage door fully. Then, secure the door in place by clamping or locking the door tracks using C-clamps or locking pliers. This ensures the door remains stationary and doesn’t move while winding the springs.
Step 5: Unwind the Existing Springs (Torsion Springs Only) For torsion springs, use the winding bars to unwind the existing tension from the springs. Insert the winding bars into the winding cone holes on each side of the spring. Slowly and carefully turn the bars in the opposite direction of the winding, loosening the tension in the spring. Repeat this process until all tension is released.
Step 6: Measure and Determine the Number of Springs Needed Take accurate measurements of the length, wire size, and diameter of the existing springs. Consult the manufacturer’s guidelines or seek professional advice to determine the correct number of springs needed for your specific garage door.
Step 7: Install New Springs (Torsion Springs) Follow the manufacturer’s instructions for installing the new springs. Typically, this involves sliding the torsion springs onto the torsion tube and securing them in place. Make sure the springs are properly centered and aligned on the tube.
Step 8: Wind the New Springs (Torsion Springs) Using the winding bars, slowly and carefully wind the new springs. Insert the winding bars into the winding cone holes and turn them in the direction indicated by the manufacturer. Wind the springs until they reach the recommended tension level, as specified by the manufacturer or a professional technician.
Step 9: Check the Balance of the Door Once the springs are wound, remove the clamps or locking pliers from the door tracks. Slowly raise and lower the garage door manually to check if it moves smoothly and remains balanced at different heights. If the door is unbalanced or exhibits any issues, consult a professional technician for further adjustments.
Step 10: Reconnect the Garage Door Opener Once you are satisfied with the balance and functionality of the garage door, plug the power supply back in and reconnect the garage door opener.
Conclusion: Winding Acclaim Garage Doors Scottsdale AZ springs is a task that requires caution, attention to detail, and proper tools. By following the step-by-step guide outlined above, you can safely and effectively wind your garage door springs. However, if you have any doubts or concerns about the process, it is always recommended to seek assistance from a professional garage door technician to ensure your safety and the optimal performance of your garage door.
Acclaim Garage Doors of Scottsdale
7400 E McDonald Dr #122, Scottsdale, AZ 85250, United States
1-480-386-1249