I can share my experience and walk you through the steps I took to replace the overhead garage door spring at my home.
Here are the steps from Garage Door Repair Encino CA that I would take:
Step 1: Gather Tools and Equipment
Before starting the replacement process, I made sure to gather all the necessary tools and equipment. I gathered new springs, a winding bar, pliers, safety glasses, and a ladder.
Step 2: Determine the Size and Type of Spring
I measured the length of the old spring and its diameter to determine the size and type of spring I needed for replacement. It’s important to match the new spring with the old one to ensure proper functioning.
Step 3: Release Tension on the Old Spring
Next, I released the tension on the old spring. This involved placing the winding bar into one of the holes on the winding cone of the spring and turning it counterclockwise to release tension. I repeated this process on the other side of the spring until all tension was released.
Step 4: Remove the Old Spring
Once the tension was released, I removed the old spring. I loosened the set screws on the winding cone with pliers and removed the screws and nuts that held the spring in place. I carefully removed the spring from the torsion tube.
Step 5: Install the New Spring
With the old spring removed, I installed the new one. I carefully placed the new spring onto the torsion tube and secured it in place with the screws and nuts that were removed earlier. I then tightened the set screws on the winding cone with pliers.
Step 6: Wind the New Spring
To wind the new spring, I placed the winding bar into one of the holes on the winding cone and turned it clockwise to tighten the spring. I repeated this process on the other side of the spring until the spring was fully wound.
Step 7: Test the Garage Door
Before finishing the replacement process, I tested the garage door to ensure that the new spring was working properly. I opened and closed the door manually to make sure it was moving smoothly and without resistance.
Step 8: Repeat the Process for the Other Spring
In my case, my garage door had two springs, so I repeated the entire process on the other spring to ensure that both springs were replaced and working properly.
In conclusion, as stated in Garage Door Repair Encino CA, replacing an overhead garage door spring is a task that requires attention to detail and safety precautions. It’s important to gather all the necessary tools and equipment, determine the size and type of spring, release tension on the old spring, remove the old spring, install the new spring, wind the new spring, test the garage door, and repeat the process for the other spring if necessary. I hope this step-by-step guide helps you in replacing your overhead garage door spring.
Sepulveda Garage & Overhead Doors
16650 Ventura Blvd #6, Encino, CA 91436, United States
818-369-3937