Garage Door Repair Chandler, AZ are an essential part of any home, and they provide protection for your vehicles and other valuable items that are stored inside your garage. One of the most important components of a garage door is the cable. Cables are responsible for holding the weight of the door, and they help the door open and close smoothly. However, like any other part of the garage door, cables can wear out and break over time. In this guide, we will discuss how to repair garage door cables.
Before we get started, it’s important to note that garage door cable repair can be dangerous, and it’s not a job for beginners. If you’re not comfortable working with garage doors, it’s best to call a professional to do the job for you. If you’re ready to tackle the job yourself, here’s what you need to know.
Step 1: Gather Your Tools
Before you begin repairing your garage door cable, you’ll need to gather a few tools. Here’s what you’ll need:
- A ladder
- A pair of vice grips
- A set of wrenches
- A replacement cable
- A cable cutter
- A socket set
- Safety glasses and gloves
Step 2: Disconnect the Opener
The first step in repairing your garage door cable is to disconnect the opener. This will prevent the door from opening or closing accidentally while you’re working on it. To do this, pull the red emergency release cord to disengage the opener from the door. You should now be able to manually open and close the door.
Step 3: Remove the Broken Cable
The next step is to remove the broken cable. First, use the vice grips to secure the door in place so that it doesn’t fall while you’re working on it. Next, loosen the bolts on the cable drum and slide the drum off of the shaft. You should now be able to remove the broken cable from the drum and the bottom bracket.
Step 4: Install the New Cable
Now it’s time to install the new cable. Begin by threading the cable through the bottom bracket and then through the cable drum. Make sure the cable is wound around the drum properly, and then tighten the bolts on the drum. Next, thread the cable through the spring and attach it to the top bracket.
Step 5: Wind the Cable
Once the cable is in place, it’s time to wind it. Use your socket set to turn the shaft until the cable is tight. Be careful not to over-tighten the cable, as this can cause the door to lift off the ground. Once the cable is tight, tighten the bolts on the cable drum to secure it in place.
Step 6: Reconnect the Opener
The final step is to reconnect the opener. To do this, pull the red emergency release cord again to re-engage the opener with the door. Test the door to make sure it’s opening and closing smoothly.
In conclusion, repairing Garage Door Repair Chandler, AZ cables can be a challenging and potentially dangerous job. If you’re not comfortable working with garage doors, it’s best to call a professional to do the job for you. However, if you’re confident in your abilities, follow these steps to repair your garage door cable safely and effectively. Remember to always wear safety glasses and gloves and to take your time to avoid any accidents.
Acclaim Garage Door of Chandler AZ
184 E Chilton Dr, Chandler, AZ 85225, United States
1-480-545-0538