If you’re looking to program your Xtreme garage door opener, I can help you out! Here are the steps to follow from Garage Door Repair Miami Gardens FL:
- First, find the “Learn” button on your garage door opener motor unit. It’s usually located on the back or side of the unit and should be labeled as such.
- Once you’ve located the “Learn” button, press and release it. This should trigger the LED light on the motor unit to start flashing, which indicates that it’s now in programming mode.
- Grab the remote control that you want to program and press and hold the button that you want to use to open and close your garage door. Keep holding the button down until the LED light on the remote control starts flashing rapidly.
- Release the button on the remote control. The LED light on the remote should stop flashing at this point.
- Within 30 seconds of pressing the button on the remote control, press the button again to test if the programming was successful. If your garage door opens or closes, then the programming was successful!
- If you have additional remote controls that you want to program, simply repeat steps 3-5 for each one.
If you have a keypad entry system for your Xtreme garage door opener, the programming process is a bit different. Here are the steps to follow:
- Find the “Learn” button on your garage door opener motor unit.
- Enter the PIN number that you want to use to open and close your garage door on the keypad entry system. The PIN can be any combination of numbers between 1-9, and it needs to be between 3 and 8 digits long.
- Within 30 seconds of entering your PIN number, press and hold the “*” button on the keypad entry system until the LED light on the system starts flashing.
- Release the “*” button on the keypad entry system. The LED light on the system should stop flashing.
- Within 30 seconds of releasing the “*” button, enter your PIN number again on the keypad entry system.
- Press the “#” button on the keypad entry system. The LED light on the system should stop flashing.
- Within 30 seconds of pressing the “#” button, test the programming by entering your PIN number on the keypad entry system and pressing the “*” button. If your garage door opens or closes, then the programming was successful!
In summary, based from Garage Door Repair Miami Gardens FL, programming your Xtreme garage door opener is a straightforward process, and following the steps above should help you get the job done quickly and easily. If you run into any issues along the way, be sure to consult the owner’s manual or reach out to Xtreme customer support for assistance.
Denzel’s Garage Door of Miami Gardens
17820 NW 27th Ave #5, Miami Gardens, FL 33056, United States
786-509-5409