A garage door seal is designed to keep out drafts, moisture, and debris from entering your garage. However, if the seal is sticking to the garage door, it can create friction and make it difficult to open and close the door.
Here are some tips from Garage Door Repair Springtown TX to keep your garage door seal from sticking:
- Clean the garage door seal Dirt, debris, and dust can accumulate on the garage door seal, causing it to stick. Clean the seal with a damp cloth or sponge to remove any buildup. Be sure to dry the seal completely after cleaning.
- Lubricate the garage door seal Applying a lubricant to the garage door seal can help it move more smoothly and reduce friction. Spray a silicone-based lubricant or garage door lubricant onto the seal and wipe off any excess with a clean cloth.
- Adjust the seal If the garage door seal is too tight against the door, it can create unnecessary friction and cause the seal to stick. Adjust the seal by loosening the screws or nails that hold it in place, and shift the seal slightly away from the door.
- Adjust the garage door If the garage door is misaligned or rubbing against the seal, it can cause the seal to stick. Adjust the garage door by following these steps:
- Open the garage door fully.
- Use a level to check whether the door is level. If it’s not, you’ll need to adjust the tension rods that hold the door in place.
- Locate the tension rods, which are usually located near the top of the door. Use a wrench to loosen the nuts on the rods.
- Adjust the rods to level the door. Turn the rods clockwise to raise the door and counter-clockwise to lower it.
- Once the door is level, tighten the nuts on the tension rods.
- Replace the garage door seal If the garage door seal is worn or damaged, it can cause it to stick to the door. Replace the seal by following these steps:
- Measure the length of the old seal and purchase a replacement seal that matches the length.
- Remove the old seal by unscrewing or prying it off the door.
- Clean the area where the seal was attached to remove any dirt, debris, or adhesive residue.
- Apply a bead of adhesive along the bottom of the garage door.
- Press the new seal onto the adhesive and hold it in place for a few minutes until it adheres.
- Check the weatherstripping If your garage door has weatherstripping in addition to the seal, it may be causing the seal to stick. Check the weatherstripping for signs of wear or damage and replace it if necessary.
To sum it up, as per Garage Door Repair Springtown TX, you can keep your garage door seal from sticking and ensure that your garage is protected from the elements. Remember to clean and lubricate the seal regularly, adjust it if necessary, and replace it if it’s worn or damaged.
Springtown TX Garage Door
205 Ave A, Springtown, TX 76082
817-373-5963