Changing the code on a Garage Door Repair Southlake TX keypad is a relatively simple process that can be accomplished in just a few steps.
In this guide, I’ll provide a step-by-step process for changing the code on a Garage Door Repair Southlake TX keypad.
Step 1: Locate the “Learn” Button
The first step in changing the code on a garage door keypad is to locate the “Learn” button on your garage door opener. This button is typically located on the back of the opener, near the antenna wire. It may also be located on the side or front of the opener.
Step 2: Clear the Existing Code
Once you have located the “Learn” button, press and hold it down for approximately 10 seconds until the indicator light on the opener turns off. This will clear the existing code from the opener’s memory.
Step 3: Enter the New Code on the Keypad
Next, enter the new code that you would like to use on the keypad. Be sure to choose a code that is easy for you to remember but difficult for others to guess. Typically, garage door keypads allow for four to six-digit codes.
Step 4: Press the “Learn” Button on the Opener
After entering the new code on the keypad, press the “Learn” button on the garage door opener. The indicator light on the opener will flash to indicate that it is ready to learn a new code.
Step 5: Enter the New Code on the Keypad Again
Once the indicator light on the opener is flashing, enter the new code on the keypad a second time. This will confirm that the new code has been successfully programmed into the opener’s memory.
Step 6: Test the New Code
To ensure that the new code is working properly, test it by pressing the numbers on the keypad and checking that the garage door opens and closes as expected.
Step 7: Repeat the Process for Additional Keypads
If you have multiple garage door keypads, you will need to repeat the above process for each keypad to ensure that all keypads are updated with the new code.
Step 8: Secure the Keypad
Once you have successfully programmed the new code into the garage door opener, be sure to secure the keypad to prevent unauthorized access. This can be done by simply removing the batteries from the keypad or by locking the keypad cover with a key.
In conclusion, changing the code on a garage door keypad is a simple process that can be accomplished in just a few steps. By following the above steps, you can update the code on your garage door keypad to keep your home and belongings safe and secure.
Dragon Garage Door & Gates
351 Central Ave #7, Southlake, TX 76092, United States
1-817-587-0445